Installation involves cutting and soldering of your engine’s wiring harness along with insertion of the blocker plate between the EGR cooler and the vehicle exhaust system. The EGR blockers have proven over time to be quite effective, but we have seen plenty of the EGR motors fail requiring replacement or upgrade to programming to fix. EGR Plate for 07-10 GM 6.6L Duramax LMM Installs in roughly 30 minutes with normal hand tools. Features: Laser Cut Stainless Steel Tab on top for easy installation 2 out of 5 Wrenches for installation (1 wrench being the easiest).Installing this will require Race Tuning to shut off the Check Engine LIght (MIL). Install the new exhaust block off plate using the factory gasket and the supplied hardware. Two M8 x 25 hex head bolts will bolt in from the back and one MIO x 20 hex head bolt will hold the bracket in place. (Note: Image shows previous bracket design). Step 23 Remove the EGR valve that is held in place with two bolts, keep one of these bolts as. I've got a ppe hot race with dpf delete and an free flowing 4 inches exhaust on my lmm 2008 dmax. I did unplug the wires frome the egr valve and notice good improvement on the low rpw no more black smoke, I intend to install the egr bloker plate next friday but i'm not shure if the ppe programmer will take care of ecu code.
- Home »
- Catalog »
- GM Duramax »
- 2001-2004 LB7 VIN Code 1 »
- 3' Y-Bridge/ EGR Kit
Browse 3' Y-Bridge/ EGR Kit Products
Egr Block Off Plate Duramax
